How to perfectly clean thread before hotend ?

General discussions regarding hardware
Post Reply
Boris
Posts: 45
Joined: Thu Jan 15, 2015 11:59 pm
Location: Moscow
Contact:
Contact Boris

How to perfectly clean thread before hotend ?

Post by Boris » Sun May 31, 2015 10:57 am

Hello, guys.

I know, there is "cloth cap" to prevent dust translate with thread to extruder. But after 1200m of filament it seems work no more because of run-out this cloth cap.

What else you doing to clean the thread before extruder ?
Felix 3.0 x2 extruders
Top
Post Reply

Return to “General”