LCD unit

This is the place to show off your felix printer hacks and improvements.
Post Reply
Mayhem
Posts: 169
Joined: Tue Jan 08, 2013 4:15 pm
Location: Finland

Re: LCD unit

Post by Mayhem » Wed Dec 10, 2014 7:54 pm

I got the graphics board but i cant find the thermistor settings that need to change for the felix hotend so can you point me where those are?
Felix 2.0----> 3.0
V4 hot end
Simplyfy 3D
Kisslicer
Autodesk fusion 360

Kalidopixel
Posts: 15
Joined: Sat Nov 09, 2013 12:20 am
Location: U.K

Post by Kalidopixel » Sat Jan 10, 2015 7:40 pm

I Thought i would share this , My Felix LCD Back light Failed after 13 Months & i Found a Perfect Low Cost Replacement Cost me just Under £6 & it has Brighter Backlight & Better Contrast to the Original Unit.

Its a Standard HD44780 (20X4) LCD Unit with Yellow / Green Backlight.

It has Automatic Contrast - Even the mounting holes are the same , Just Solder wires or add a header plug :)

Image

stillcool40
Posts: 33
Joined: Sun Mar 30, 2014 1:59 pm

Post by stillcool40 » Sun Jul 16, 2017 6:35 am

has anyone actually fitted one of these displays to a felix ramps? if so some clear and detailed instructions for those of us who are NOT electronics wizards would be greatly appreciated.

Post Reply