Bed support

This is the place to show off your felix printer hacks and improvements.
Post Reply
Mayhem
Posts: 169
Joined: Tue Jan 08, 2013 4:15 pm
Location: Finland

Bed support

Post by Mayhem » Mon Feb 10, 2014 1:52 pm

Just want to test if i can reduce the vibrations of the bed, and i am a noob when it comes to 3d modelling so reply if something is totally wrong or will it even work at all :D

I have smooth rod and bearings lying around so ill give it a try, printing parts now :)
Attachments
Bed support.png
Felix 2.0----> 3.0
V4 hot end
Simplyfy 3D
Kisslicer
Autodesk fusion 360

Mayhem
Posts: 169
Joined: Tue Jan 08, 2013 4:15 pm
Location: Finland

Post by Mayhem » Tue Feb 11, 2014 10:18 am

Parts served their purpose. the "smooth"rod and the those bearings are joke :D
Not even close to smooth and straight, those rods cause huge mount of friction :lol:
Felix 2.0----> 3.0
V4 hot end
Simplyfy 3D
Kisslicer
Autodesk fusion 360

dognotdog
Posts: 181
Joined: Tue Sep 04, 2012 9:22 pm

Post by dognotdog » Tue Feb 11, 2014 11:23 am

The Hiwin rails are much, much stiffer than the 8mm rod/bearing setup. Especially if you used cheap bearings.

Post Reply