Anyone done auto bed levelling?

This is the place to show off your felix printer hacks and improvements.
Post Reply
andrewsi
Posts: 130
Joined: Mon Dec 23, 2013 1:26 am

Anyone done auto bed levelling?

Post by andrewsi » Sat Feb 01, 2014 8:24 pm

Has anyone found a way to add auto-bed leveling (e.g. points to connect a Z-switch and/or servo to the 2.0/2.1 electronics board?) There's a few unused jumpers labeled "OPT" on the 2.1 board but I don't know what they're connected to. Also, I only have one extruder, so I suppose there might be a way to reconfigure the pins.h in Marlin to use the unused thermistor pins to act as a switch sensor.

I'm curious if anyone else has done anything along these lines.
__________________________________________
Andy Silverman, Technogeek in Seattle
Felix Tec4 Single-head

seaton
Posts: 291
Joined: Tue May 14, 2013 9:04 am
Location: Bunbury, Western Australia
Contact:

Post by seaton » Sun Feb 02, 2014 12:05 pm

andrewsi wrote:Has anyone found a way to add auto-bed leveling (e.g. points to connect a Z-switch and/or servo to the 2.0/2.1 electronics board?) There's a few unused jumpers labeled "OPT" on the 2.1 board but I don't know what they're connected to. Also, I only have one extruder, so I suppose there might be a way to reconfigure the pins.h in Marlin to use the unused thermistor pins to act as a switch sensor.

I'm curious if anyone else has done anything along these lines.
no but am interested myself
Stephen...

Felix 2.0 -> Felix 3.0 dual
Simplify3D Slicer, Kisslicer
Have you added your Felix to the Map? http://goo.gl/maps/HajnZ

http://blog.strobotics.com.au


andrewsi
Posts: 130
Joined: Mon Dec 23, 2013 1:26 am

Post by andrewsi » Sun Feb 02, 2014 5:29 pm

The thingiverse post says he's not using the Felix electronics. Which brings me back to the question if whether any of the unused pins on a single extruder 3.0 could be repurposed for that.
__________________________________________
Andy Silverman, Technogeek in Seattle
Felix Tec4 Single-head

Post Reply