Wide kypton tape...

This is the place to show off your felix printer hacks and improvements.
Post Reply
Tim
Posts: 5
Joined: Sun Dec 22, 2013 4:31 am

Wide kypton tape...

Post by Tim » Tue Jan 07, 2014 3:04 pm

I am looking at making a bulk order to get 250mm x 10m krypton tape. Expecting a roll to be about $25-30 depending on what I get for shipping. Is anyone interested?

Tim

hvdweerd
Posts: 26
Joined: Mon Sep 30, 2013 10:48 am
Location: Netherlands

Post by hvdweerd » Wed Jan 08, 2014 10:01 am

Why you don't use a glass plate?

seaton
Posts: 291
Joined: Tue May 14, 2013 9:04 am
Location: Bunbury, Western Australia
Contact:

Post by seaton » Thu Jan 09, 2014 9:52 am

This stuff is a bitch to stick on correctly without bubbles as it's just way too wide to handle properly when installing, I ended up giving up on it and now using glass.
Stephen...

Felix 2.0 -> Felix 3.0 dual
Simplify3D Slicer, Kisslicer
Have you added your Felix to the Map? http://goo.gl/maps/HajnZ

http://blog.strobotics.com.au

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer » Fri Jan 10, 2014 5:41 pm

Just spray the plate with soap water and rub the bubbles away. Just be carful for the electronics.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Mayhem
Posts: 169
Joined: Tue Jan 08, 2013 4:15 pm
Location: Finland

Post by Mayhem » Fri Jan 10, 2014 9:25 pm

Buy 2mm photo glass frame and but water/wood glue mix on top of the glass.
Felix 2.0----> 3.0
V4 hot end
Simplyfy 3D
Kisslicer
Autodesk fusion 360

Post Reply