New extruder carriage design for E3D Bowden Hot end V5

This is the place to show off your felix printer hacks and improvements.
Post Reply
eturner
Posts: 7
Joined: Wed Jun 19, 2013 3:47 pm

Re: New extruder carriage design for E3D Bowden Hot end V5

Post by eturner » Tue Jun 21, 2016 7:48 am

I'm sure this is a stupid question but can't find an answer anywhere. Do you purchase the 12 or 24v hot end?

Sven_Felix
Posts: 8
Joined: Tue Apr 26, 2016 11:03 am

Post by Sven_Felix » Wed Jun 22, 2016 9:07 am

Hi Eturner,

The Felix version 1.0 untill version 3.1 runs on 12V.

Post Reply