Page 1 of 1

leaking hotend Felix tec 4

Posted: Sun Jan 28, 2018 3:44 pm
by CesarineHiddink
When I'm printing with one of the extruders, left or right that is the same no difference, the prints are perfect. But when I try to print with both extruders, two different colors PLA, with support and Oozeshield, than the right one is leaking filament, both below and above. When I print with only the right extruder, it isn't leaking. What can I do to prevent this?
Because of this, the print is at the end not as beautiful as the print with one extruder.
Finally I want to print with PVA in one extruder for the support.

Re: leaking hotend Felix tec 4

Posted: Tue Jan 30, 2018 8:07 am
by gfeliksdal
Hello Cesarine,
What slicing settings do you use? Do you see that the nozzles cool down during nozzle switching? If this is not the case, you will see this leakage.

Re: leaking hotend Felix tec 4

Posted: Tue Jan 30, 2018 2:50 pm
by CesarineHiddink
yes they are cooling down during switching till 130 C.

Re: leaking hotend Felix tec 4

Posted: Tue Jan 30, 2018 2:56 pm
by CesarineHiddink
bijgevoegd de slicings