Page 1 of 1

My Version of Felix 2.0 call it 2.5

Posted: Fri Jan 05, 2018 2:30 am
by Hardy123
Here is my Felix Conversion :-)

Firmware Marlin Rc 1.1.8
Energy Chains
Mainboard Led housing shows the temperature ( green cold / purple middle / red hot )
Sensor is inside the Heatbed .

Dual Extruder with a Servo from Thingverse Dondolo V1
I Adapted the Plate for the Felix.

LED lighting Bar

After My Test the Dondolo Works not well !!!
Not Enought Pressure from Sensor !
Please Not Build this

greetings Hardy

Re: My Version of Felix 2.0 call it 2.5

Posted: Fri Jan 05, 2018 12:07 pm
by janwijbrand
Nice conversion!

Re: My Version of Felix 2.0 call it 2.5

Posted: Mon Jan 08, 2018 5:57 pm
by Gabrielber
Looking good! Is the custom dual extruder light enough or does it cause more ripples / ringing than usual?