My Version of Felix 2.0 call it 2.5

This is the place to show off your felix printer hacks and improvements.
Post Reply
Posts: 11
Joined: Fri Jan 05, 2018 1:50 am

My Version of Felix 2.0 call it 2.5

Post by Hardy123 » Fri Jan 05, 2018 2:30 am

Here is my Felix Conversion :-)

Firmware Marlin Rc 1.1.8
Energy Chains
Mainboard Led housing shows the temperature ( green cold / purple middle / red hot )
Sensor is inside the Heatbed .

Dual Extruder with a Servo from Thingverse Dondolo V1
I Adapted the Plate for the Felix.

LED lighting Bar

After My Test the Dondolo Works not well !!!
Not Enought Pressure from Sensor !
Please Not Build this

greetings Hardy
Add description
Add description
Add description
Add description
Last edited by Hardy123 on Thu Feb 28, 2019 11:04 pm, edited 1 time in total.

User avatar
Posts: 37
Joined: Thu Dec 24, 2015 4:22 pm

Post by janwijbrand » Fri Jan 05, 2018 12:07 pm

Nice conversion!
Felix 3.1 single extruder, soon to be Tec 4 dual

Posts: 6
Joined: Fri Dec 22, 2017 2:51 pm

Post by Gabrielber » Mon Jan 08, 2018 5:57 pm

Looking good! Is the custom dual extruder light enough or does it cause more ripples / ringing than usual?

Post Reply