Page 1 of 1

E3D Chimera and Cyclops?

Posted: Sat Mar 28, 2015 10:22 pm
by kerog
Has anyone looked at adapting one or both of these for the Felix?

http://e3d-online.com/Multi-Extrusion

Satoer? Do you have an in with E3D based on your adaptation of their hot end for the Felix?

I keep getting tempted to try out the E3D, but don't want to give up my dual extrusion capability. :-(

Anyone know if Felix is making progress on a new hot end?

-Keith

Re: E3D Chimera and Cyclops?

Posted: Sun Mar 29, 2015 2:12 pm
by fanass
Hi KEITH,

I ordered a chimera hotend in january and they shipped it this week. I will build a Chimera-mount for felix and print a second extruder in the next few weeks. At the moment, i'm using an E3D v6.

- Hans

Re: E3D Chimera and Cyclops?

Posted: Sun May 31, 2015 8:12 am
by kerog
fanass wrote:Hi KEITH,

I ordered a chimera hotend in january and they shipped it this week. I will build a Chimera-mount for felix and print a second extruder in the next few weeks. At the moment, i'm using an E3D v6.

- Hans
Any progress to report? Wondering if I should put in an order...

Re: E3D Chimera and Cyclops?

Posted: Mon Aug 21, 2017 5:10 pm
by kerog
kerog wrote:
fanass wrote:Hi KEITH,

I ordered a chimera hotend in january and they shipped it this week. I will build a Chimera-mount for felix and print a second extruder in the next few weeks. At the moment, i'm using an E3D v6.

- Hans
Any progress to report? Wondering if I should put in an order...
I pulled the trigger and bought the Chimera; now I'm trying to figure out if I want to install it on my Felix or my Rostock. Have you made any progress on a Felix mount?