E3D Chimera and Cyclops?

This is the place to show off your felix printer hacks and improvements.
Post Reply
kerog
Posts: 117
Joined: Mon Jun 09, 2014 1:54 am

E3D Chimera and Cyclops?

Post by kerog » Sat Mar 28, 2015 10:22 pm

Has anyone looked at adapting one or both of these for the Felix?

http://e3d-online.com/Multi-Extrusion

Satoer? Do you have an in with E3D based on your adaptation of their hot end for the Felix?

I keep getting tempted to try out the E3D, but don't want to give up my dual extrusion capability. :-(

Anyone know if Felix is making progress on a new hot end?

-Keith

fanass
Posts: 22
Joined: Mon Oct 20, 2014 6:51 am

Post by fanass » Sun Mar 29, 2015 2:12 pm

Hi KEITH,

I ordered a chimera hotend in january and they shipped it this week. I will build a Chimera-mount for felix and print a second extruder in the next few weeks. At the moment, i'm using an E3D v6.

- Hans

kerog
Posts: 117
Joined: Mon Jun 09, 2014 1:54 am

Post by kerog » Sun May 31, 2015 8:12 am

fanass wrote:Hi KEITH,

I ordered a chimera hotend in january and they shipped it this week. I will build a Chimera-mount for felix and print a second extruder in the next few weeks. At the moment, i'm using an E3D v6.

- Hans
Any progress to report? Wondering if I should put in an order...

kerog
Posts: 117
Joined: Mon Jun 09, 2014 1:54 am

Post by kerog » Mon Aug 21, 2017 5:10 pm

kerog wrote:
fanass wrote:Hi KEITH,

I ordered a chimera hotend in january and they shipped it this week. I will build a Chimera-mount for felix and print a second extruder in the next few weeks. At the moment, i'm using an E3D v6.

- Hans
Any progress to report? Wondering if I should put in an order...
I pulled the trigger and bought the Chimera; now I'm trying to figure out if I want to install it on my Felix or my Rostock. Have you made any progress on a Felix mount?

Post Reply