My Felix has a new home

This is the place to show off your felix printer hacks and improvements.
Post Reply
gertc
Posts: 2
Joined: Sat Jun 28, 2014 3:31 pm

My Felix has a new home

Post by gertc » Mon Aug 18, 2014 8:49 am

... and he likes it.

Room for up to 30 spools with moisture absorber, led lighting, enclosed cabinet such that noise and particulates stay in, and cold drafts out.
What more can a 3d printer wish for?

Image
Image

Dreide
Posts: 176
Joined: Sun Sep 29, 2013 12:32 am
Location: Lausanne, Switzerland

Post by Dreide » Mon Aug 18, 2014 10:16 pm

Wow, very nice! Your printer is for sure a lucky one.
Felix 2.0->3.0dual * Repetier (host+firmware) * KISSlicer Pro, Simplify3D * Cubify Design

fl_enoc
Posts: 6
Joined: Sun Oct 20, 2013 4:46 am

Post by fl_enoc » Sat Sep 13, 2014 8:35 pm

this is a really good house for it, i hope you could share the source.

Congrats

3DPrintClean
Posts: 2
Joined: Sun Mar 01, 2015 7:24 pm

Post by 3DPrintClean » Tue Mar 03, 2015 1:40 am

If interested, my company is developing a low cost 3D Printer enclosure that filters odors and particles, please see http://www.3dprintclean.com to learn more.

fesch
Posts: 35
Joined: Fri Dec 05, 2014 11:14 pm
Location: Luxembourg
Contact:

Post by fesch » Wed Mar 04, 2015 11:33 am

Looking at mine, I think I should go a get something similar :-/

3DPrintClean
Posts: 2
Joined: Sun Mar 01, 2015 7:24 pm

Post by 3DPrintClean » Wed Mar 04, 2015 4:48 pm

@3DPrintClean is developing two recirculating filtration products for existing enclosures, one that can be placed inside the enclosure and the other that is mounted to the outside of the enclosure, the second requires enclosure cutouts but leaves more room for the printer.

http://3dprintclean.com/blog/2015/03/01 ... 3d-printer

http://3dprintclean.com/blog/2015/02/27 ... enclosures

If interested, please contact sales@3DPrintClean.com

Boris
Posts: 45
Joined: Thu Jan 15, 2015 11:59 pm
Location: Moscow
Contact:

Post by Boris » Thu Mar 05, 2015 3:34 pm

Hello.

Someone at this forum told about bad effect of heat for belts.

Don't you afraid belts destruct or melt or tear off by overheat ?
Felix 3.0 x2 extruders

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer » Thu Mar 05, 2015 10:33 pm

One concerning thing I can think of is the bending of PLA printed printer parts. The latest revision of the Felix has injected moulded parts, but older printers has printed parts. These printed parts can get soft when the temperature gets around 60 degrees.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Post Reply