Assembly Manual Felix 3.1 - Step 43

Help eachother out with assembly problems.
Post Reply
dobst
Posts: 2
Joined: Mon Oct 03, 2016 8:22 pm

Assembly Manual Felix 3.1 - Step 43

Post by dobst » Tue Oct 04, 2016 7:19 pm

Hello all,

my school just purchased a Felix 3.1 DIY Kit and we stumbled at step 43. The instruction says we need 3 Bolts (M3x16) but from the picture (and the part itself) we don't see where to place them - can anyone help?

Here is a screenshot from step 43 is attached.
step43.PNG
step43.PNG (85.98 KiB) Viewed 1767 times
Best regards,
David

User avatar
gfeliksdal
Site Admin
Posts: 400
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Post by gfeliksdal » Wed Oct 05, 2016 7:35 am

Hi David,

That seems to be a typo. You only need a m4x12 bolt + nut to retain the spring.

dobst
Posts: 2
Joined: Mon Oct 03, 2016 8:22 pm

Post by dobst » Wed Oct 05, 2016 12:58 pm

Great!

Is it possible that - even after following every single step - there are some bolts, nuts and washers are left over?

The assembly manual wasn't very clear about the fan that is placed on top of both nozzles. Does the sticker on the fan face to the outside (to the user of the printer) or to the inside? Saw both versions on different pictures on the web.

Thanks for your fast reply!

David

User avatar
gfeliksdal
Site Admin
Posts: 400
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Post by gfeliksdal » Wed Oct 05, 2016 10:30 pm

Hi David,

The sticker on the fan should face towards the hot-ends (inwards). There should indeed be some bolts left. Approx 5 to 10% extra for each bolt type, just in case you loose some.

Post Reply