Overhangs

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
3dn
Posts: 1
Joined: Sun Aug 21, 2016 7:16 am

Overhangs

Post by 3dn » Sun Apr 16, 2017 4:38 pm

Happy Easter!
I have a problem with printing from overhangs (see photos). For several weeks it has become worse. What can I do?
I own a Felix 3.0 with newest Repetierfirmware.
Cura as a slicer.
Felixprinters PLA Filament

The model comes from http://www.thingiverse.com/thing:2217436

Regards
3dn
Attachments
2017-04-16 16.35.57.jpg
2017-04-16 11.55.04.jpg
2017-04-16 11.53.45.jpg
2017-04-16 11.52.47.jpg

ElektrOpa
Posts: 15
Joined: Fri Apr 21, 2017 3:16 pm

Post by ElektrOpa » Fri Apr 21, 2017 4:19 pm

Hi, I am not sure, but I had similar problems with overhangs. They were warping up (one would expect,they warp down due to gravity) due to bad or missing cooling. Are you sure you have checked the cooling option in the slicer and your little blower is running with full speed. If not, just give it a try.

Post Reply