how to do two color prints

Discussions about firmware/slicing software, tweaks and settings
Post Reply
new3d
Posts: 1
Joined: Wed May 21, 2014 7:47 am

how to do two color prints

Post by new3d » Wed May 21, 2014 7:54 am

I want to do a two color print witrh the Felix 3.0, but I can't get any manual how to do this?
I have two STL files (each for one color) that fit together. What kind of software do I need to load the models and assign the extruders?

Hugues
Posts: 270
Joined: Thu Apr 04, 2013 5:36 pm

Post by Hugues » Wed May 21, 2014 6:38 pm

i think slic3r.org does this
Hugues
Regards from Switzerland

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer » Wed May 21, 2014 8:20 pm

Take a look at this video:
https://www.youtube.com/watch?v=8RXIGjRG-Gc
Different printer, same software.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Post Reply