Slowing Down Print Speed in SFACT

Discussions about firmware/slicing software, tweaks and settings
Post Reply
stiffmasters
Posts: 8
Joined: Fri Sep 27, 2013 2:13 pm

Slowing Down Print Speed in SFACT

Post by stiffmasters » Wed Feb 26, 2014 12:04 pm

Hi everyone,

I've been printing very successfully for a few months with PLA using the standard SFACT profiles. However, i've ordered some Ninjaflex filament and it's recommended to slow down the print speed to about 25-35%. I've had a look around the SFACT profiles (and to be honest I'm not sure what most of the settings do) and I've read the SFACT manual and it seemed to go over my head.

Is there a way to simply slow down the whole print, without having to tweak flow and feed rate for each section of SFACT?

Any help is much appreciated!

Thanks
Jason

Makron
Posts: 110
Joined: Wed Mar 20, 2013 1:29 pm

Post by Makron » Thu Feb 27, 2014 9:25 am

set this lower and it will print slower. haha :D
Attachments
Untitled.png

Saamec
Posts: 157
Joined: Fri Jun 21, 2013 9:28 am

Post by Saamec » Thu Feb 27, 2014 9:49 am

:lol: :lol: :lol: :lol:

stiffmasters
Posts: 8
Joined: Fri Sep 27, 2013 2:13 pm

Post by stiffmasters » Wed Mar 19, 2014 10:48 am

Wow, that easy huh! Thanks mate!

Post Reply