Repetier 1.5.6 update ???

Discussions about firmware/slicing software, tweaks and settings
Post Reply
alanh
Posts: 78
Joined: Tue Jul 23, 2013 7:08 pm

Repetier 1.5.6 update ???

Post by alanh » Fri Oct 02, 2015 12:44 am

Is Felix Printers going to update us to 1.5.6 ?

I can't get 1.0.6 to work properly with my 3D graphics card as it crashes at startup.

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer » Fri Oct 02, 2015 11:47 am

Why don't you use the non-Felix branded Repetier? Works fine.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

agentmulder
Posts: 49
Joined: Sat May 10, 2014 2:54 am

Post by agentmulder » Sat Nov 21, 2015 11:12 pm

I may have the same issue (crashes at start up).

I have downloaded RH 1.6, but am unsure of the printer settings. I copied them over from my mac version RH 0.56 but not all settings are the same.

Regardless I get 'no start signal detected'.

Any help appreciated:

http://www.felixprinters.com/forum/view ... f=5&t=1812

agentmulder
Posts: 49
Joined: Sat May 10, 2014 2:54 am

Post by agentmulder » Sat Nov 21, 2015 11:17 pm

satoer wrote:Why don't you use the non-Felix branded Repetier? Works fine.
Because we don't know what we don't know.

It's reasonable to expect that if someone (felix) makes their own 'branded' version of a software that they would do this for a specific reason - i.e. the standard application wont work for some reason.

Anyway, that was my expectation :)

I tried it eventually, but pretty much as a last resort. I still have issues, but until I read your post I wasn't sure it was because of some 'hidden' felix-specific features of the RH version available in the downloads section of this website.

Even then, I'm not 100% sure (i.e. don't trust every forum post)

Post Reply