Error FelixBuilder

Discussions about firmware/slicing software, tweaks and settings
Post Reply
Al3x
Posts: 1
Joined: Sun Aug 09, 2015 4:24 pm

Error FelixBuilder

Post by Al3x » Sat Aug 15, 2015 11:56 am

Hello,
hello, I have a problem with the software Felix Builder.
When I start to print a job I get an error message, and yet it prints me the job. The error message says "Object reference not set to an object instance". the original error message is in German "Der Objektverweis wurde nicht auf eine Objektinstanz festgelegt".

See Photo!

The software I have removed and reinstalled, but the problem is still there. I do not know more, you can help me please ?!

I use google translator because my English is not so good :roll:
Attachments
Error Felixbuilder.jpg

Post Reply