Page 1 of 1

Bug Repetier Mac Host with gcode from kisslicer

Posted: Mon Mar 02, 2015 8:23 pm
by Marcio Ambrosio
Hello Guys!
I have a problem printing gcode created with kisslicer (on PC) and loaded in Repetier host on a mac system. It seems that it doesn't extrude and doesn't recognize the good x/y/z values. Cant' print anything…
When loading this same gcode in Repetier Pc host, works perfect!

Does anybody have this bug and solve it?
I'm working with Felix 3.0 last firmware.

Thank's for helping

Re: Bug Repetier Mac Host with gcode from kisslicer

Posted: Wed Mar 04, 2015 11:34 am
by fesch
I have a Mac an do not have in problems in any combination with these software. I use a PC, my Mac as well as direct printing from the SD-card ...