is the v0.92 firmware relevant to Felix2 models?

Discussions about firmware/slicing software, tweaks and settings
Post Reply
agentmulder
Posts: 49
Joined: Sat May 10, 2014 2:54 am

is the v0.92 firmware relevant to Felix2 models?

Post by agentmulder » Wed Feb 04, 2015 4:36 am

Can someone confirm - is:

20141208 - FIRMWARE - Repetier 0.92 - FELIX_3_0_SINGLE_extrusion.zip

relevant to Felix 2 units ?

If so, maybe the file name could be more general ?

If not, are there any further firmware upgrades for older models such as the Felix 2 ?

Thanks

agentmulder
Posts: 49
Joined: Sat May 10, 2014 2:54 am

Post by agentmulder » Tue Feb 10, 2015 11:08 am

anyone??

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer » Wed Feb 11, 2015 2:15 pm

I believe there are no mechanical changes between the 2 and the 3. Same pinions on the extruder, X and Y. Same spindle on the Z. And same electronics... So I guess It should work fine. Just keep a copy of the old firmware before upgrading. You can always downgrade. And, if there where hardware changes you can always re-calibrate and store it in the EEPROM. (accessible through the “Firmware EEPROM configuration” in the configuration menu from Repetier host.)
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Post Reply