Different Speed for Each Extruder ?

Discussions about firmware/slicing software, tweaks and settings
Post Reply
livingstereo1991
Posts: 6
Joined: Tue Jan 28, 2014 3:39 am

Different Speed for Each Extruder ?

Post by livingstereo1991 » Fri Aug 22, 2014 5:45 am

Hey all,

I have been playing with kisslicer for a while and I'm wondering if there is a setting to assign different speed for each extruder? Say I want to print PLA at 50mm/s while the PVA as support will print as 10mm/s. I'm thinking this would greatly reduce the print speed for dual head printing. Thanks :)

Angus

frankjoke
Posts: 150
Joined: Sat Dec 28, 2013 6:07 pm

Post by frankjoke » Fri Aug 22, 2014 10:18 pm

You may manage by adjusting feed in material code and including it when changing tool.

Post Reply