Page 1 of 1

Message

Posted: Sat Jul 20, 2019 3:30 pm
by Pannekoek
I have twice got the message firmware requested pause. I was able to restart the printing process but I have no idea what is the course of the message because filament detection was disabled.
Can somebody help me?

Re: Message

Posted: Sat Jul 20, 2019 9:51 pm
by gfeliksdal
Hi Pannekoek,

Normally this message only can be displayed when there is a filament detection but it can also appear when there is an error for for instance the heaters. Please check if the issue is not with that.