Page 1 of 1

Moving the extruder away from printed piece at the conclusion of printing

Posted: Mon Feb 06, 2017 3:31 am
by crotpants
Hi,

The profiles that load for "Felix 2.0" – (Actually using 3.0 profile) within Simplfy3D don't move print head away from model when done.

Am i missing some setting?

Ben

Re: Moving the extruder away from printed piece at the conclusion of printing

Posted: Tue Dec 12, 2017 4:11 pm
by CesarineHiddink
I have the same problem with my Tec 4 and I cannot find the solution. Anybody who fixed this yet?

Re: Moving the extruder away from printed piece at the conclusion of printing

Posted: Wed Dec 13, 2017 4:49 pm
by frankjoke
In Simplify go to scripts and ending script and put something in like this:

G91 ; Make coordinates relative
G1 Z2 F1000 ; Move z 2mm up
G90 ; Use absolute coordinates again
G1 X0 Y0 F1000 ; Move bed and printhead to ergonomic position

This would move the hed up 2mm and then go to the x/y-0

Re: Moving the extruder away from printed piece at the conclusion of printing

Posted: Thu Dec 14, 2017 9:59 pm
by gfeliksdal
Also make sure to load the latest slice profiles from our download section. The slice profiles in simplify3D are very basic.

Re: Moving the extruder away from printed piece at the conclusion of printing

Posted: Mon Aug 27, 2018 6:16 am
by steve3dprinters
I reckon some part of the final 3D printer settings might be missing and you need to check this. Get assistance from the user manual of your 3D printer to know about this better.