Page 1 of 1

Selling my FelixPrinter 3.1 + modifications

Posted: Mon Mar 27, 2017 7:47 pm
by ErikL
Hi,

I have a FelixPrinters 3.1 dual-extruder printer with the following modifications:

1. Better bed-support. So the bed is supported at 5 points (middle + corners) -> bed can be leveled better.
2. Firmware replaced with Marlin (=better than original Repetier firmware in many aspects)
3. Buildtak flexplate system instaslled
4. BLTouch sensor -> auto bed leveling... no more manual tuning of Z-height.

I want to sell this printer and If you're interested, please let me know.

Thanks

Re: Selling my FelixPrinter 3.1 + modifications

Posted: Wed Mar 29, 2017 7:12 am
by ErikL
And I forgot to mention:

5. Anti-backlash nuts on the Z-Axis.


PS: I live in Belgium so shipping within Europe only.

Re: Selling my FelixPrinter 3.1 + modifications

Posted: Wed Mar 29, 2017 12:30 pm
by ErikL
and also:

6. Improved fans for better print cooling -> this also improved the print quality quite a lot ;)

Re: Selling my FelixPrinter 3.1 + modifications

Posted: Sat Apr 22, 2017 10:15 am
by 3Diy
Hello ErikL,
I have a question:
can you share your modification you made to the cooling and your marlin firmware/configuration?
Im currently working on a advanced cooling system but till now i was unable to improve the print quality

Re: Selling my FelixPrinter 3.1 + modifications

Posted: Sat Apr 22, 2017 5:49 pm
by ElektrOpa
3Diy wrote:Hello ErikL,
I have a question:
can you share your modification you made to the cooling and your marlin firmware/configuration?
Im currently working on a advanced cooling system but till now i was unable to improve the print quality
I would be interested too ;-)