Selling my FelixPrinter 3.1 + modifications

General discussions regarding hardware
Post Reply
ErikL
Posts: 11
Joined: Mon Feb 01, 2016 11:24 pm

Selling my FelixPrinter 3.1 + modifications

Post by ErikL » Mon Mar 27, 2017 7:47 pm

Hi,

I have a FelixPrinters 3.1 dual-extruder printer with the following modifications:

1. Better bed-support. So the bed is supported at 5 points (middle + corners) -> bed can be leveled better.
2. Firmware replaced with Marlin (=better than original Repetier firmware in many aspects)
3. Buildtak flexplate system instaslled
4. BLTouch sensor -> auto bed leveling... no more manual tuning of Z-height.

I want to sell this printer and If you're interested, please let me know.

Thanks

ErikL
Posts: 11
Joined: Mon Feb 01, 2016 11:24 pm

Post by ErikL » Wed Mar 29, 2017 7:12 am

And I forgot to mention:

5. Anti-backlash nuts on the Z-Axis.


PS: I live in Belgium so shipping within Europe only.

ErikL
Posts: 11
Joined: Mon Feb 01, 2016 11:24 pm

Post by ErikL » Wed Mar 29, 2017 12:30 pm

and also:

6. Improved fans for better print cooling -> this also improved the print quality quite a lot ;)

3Diy
Posts: 11
Joined: Wed Apr 13, 2016 9:53 pm

Post by 3Diy » Sat Apr 22, 2017 10:15 am

Hello ErikL,
I have a question:
can you share your modification you made to the cooling and your marlin firmware/configuration?
Im currently working on a advanced cooling system but till now i was unable to improve the print quality

ElektrOpa
Posts: 15
Joined: Fri Apr 21, 2017 3:16 pm

Post by ElektrOpa » Sat Apr 22, 2017 5:49 pm

3Diy wrote:Hello ErikL,
I have a question:
can you share your modification you made to the cooling and your marlin firmware/configuration?
Im currently working on a advanced cooling system but till now i was unable to improve the print quality
I would be interested too ;-)

Post Reply