Height of the printed parts not correct - help needed

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
mhoi
Posts: 3
Joined: Sat Oct 14, 2017 7:40 pm

Height of the printed parts not correct - help needed

Post by mhoi » Fri Aug 24, 2018 7:38 pm

Have problem with my Felix Tec4 (latest FW dual v08 -20171207) when printing bigger parts, part height gets too high. When I print small calibration cube 20mm x-y-z, size is correct . I have checked also movement by manual control it is correct so esteps to Z axis should be ok. I'm using cura engine in slicing

object size x-y-z 175-95-38.75 gets printed 175-95- 44.6 mm

I would appreciate some direction on how to solve such problem. Cheers -Matti

mhoi
Posts: 3
Joined: Sat Oct 14, 2017 7:40 pm

Post by mhoi » Mon Sep 03, 2018 5:42 pm

Turning to investigate physical setup I found out z axis connection to lead screw was loose , height prints now good. :D

Post Reply