FELIXprinters Forum

Welcome to the FELIXprinters community. A great place to share your 3D printing experience and get the most out of your 3D printer.

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

By Blackdam
#11762
Hi guys,
I submit a new problem occurred after changing the mother board of my Felix 3 printer.

After replacing the board, I have the Z motor working on wrong direction and not returning to home position anymore. If I give control to go full up, it stop a couple of centimeters before reach the optical sensor, and also when clicking to go to home position it goes down a cm and it stop, instead of go up until reach the optical sensor.

Anyone know how to help me?

Best Regards

BD
long long title how many chars? lets see 123 ok more? yes 60

We have created lots of YouTube videos just so you can achieve [...]

Another post test yes yes yes or no, maybe ni? :-/

The best flat phpBB theme around. Period. Fine craftmanship and [...]

Do you need a super MOD? Well here it is. chew on this

All you need is right here. Content tag, SEO, listing, Pizza and spaghetti [...]

Lasagna on me this time ok? I got plenty of cash

this should be fantastic. but what about links,images, bbcodes etc etc? [...]