FELIXprinters Forum

Welcome to the FELIXprinters community. A great place to share your 3D printing experience and get the most out of your 3D printer.

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

By Blackdam
#11761
Hi guys,
I write you as I have a new problem with my Felix 3.0.

The Extruder motor suddendly stopped working after 3 years of activity, this happened after the filament got stuck while I was away, thing already happened in the past some times.
I noticed the motor wasn't working anymore, so I tried to replace it with a new one, but it still doesn't work. I also replaced the whole mother board with a new one, and the motor (only this one) still doesn't work on manual control.

If I launch a print, while printing the pinion run, so the motor is working, but on manual control there is no way to make it move (eg for filament change or so).

Anyone can help me?

Best Regards

BD
long long title how many chars? lets see 123 ok more? yes 60

We have created lots of YouTube videos just so you can achieve [...]

Another post test yes yes yes or no, maybe ni? :-/

The best flat phpBB theme around. Period. Fine craftmanship and [...]

Do you need a super MOD? Well here it is. chew on this

All you need is right here. Content tag, SEO, listing, Pizza and spaghetti [...]

Lasagna on me this time ok? I got plenty of cash

this should be fantastic. but what about links,images, bbcodes etc etc? [...]