No smooth edges when printing PLA on PVA with a dual extruder

Moderator: speedake95

Post Reply
CesarineHiddink
Posts: 5
Joined: Sun Nov 26, 2017 2:21 pm

No smooth edges when printing PLA on PVA with a dual extruder

Post by CesarineHiddink » Sat Feb 24, 2018 3:14 pm

When I'm printing PLA on PVA as supportmaterial and after finishing and resolving the PVA, my product is not so beautiful on the edges of the two materials. See my photo. I don't know what to do to resolve this problem. I have tried different settings of temperature. I am using Simplify3d. The top layer is the one which was sticking on the PVA at the heating bed.
I also did use support in the holes of the bracelet and had the same ugly layers!

What will be the solution of this problem?
Attachments
20180224_150755.jpg

Post Reply