Page 1 of 1

Duet control board

Posted: Tue Jan 14, 2020 7:07 pm
by Deluka
For the moment I have a vanilla TEC 4.1
But lately having a lot of problems with random under extruding and homing to the wrong place.
After checking and cleaning everything I can and recalibrating everything I think there is problem with the control board. Now I'm thinking about buying a duet. is there anybody here who has done this conversion successfully. Any advise is welcome

Re: Duet control board

Posted: Sun Jun 07, 2020 12:50 pm
by Deluka
I made the move and bought myself a duet3d. the firmware settings are taken over and the printer does a fantastic job. it is now so quiet that the only noise now comes from the fans. the bed leveling is better. I never managed to use my full bed, but now I do. the endstops can be made to work by taking 5V from a free connection and placing a resistor. I1 can definitely recommend this upgrade